Draw vertical lines to fill the entire main window in SmartForm

By Jayshree Santosh Mahajan, Cognizant Technology Solutions

Introduction:

Recently I got a requirement of smart form and in which I had to draw the vertical lines till the end of the main window, even though there are few records.

I tried searching the solution on internet but could not land to a suitable webpage, so thought to share the solution.

Scenario:

Say, the table in the main window is displaying records like,

And we want to display the same records in the following format,

Here are the steps to achieve our goal:                    

1.     Create the line type with the intended number of columns. In this example, I have created the line type with 7 columns (%LTYPE1). They would serve as headers.

2.     Create the exactly same line type for the data display. Here I have created %LTYPE2.

3.     For line type %LTYPE1 select the below frame  

4.     For the line type  %LTYPE2 select below frame

Note: It will remove the horizontal lines as well. If you want to keep the horizontal lines then keep the lower line and remove only left, right and upper line by selecting the line type in the table painter.  

5.     It would look like

Click here to continue...

Please send us your feedback/suggestions at webmaster@SAPTechnical.COM 

HomeContribute About Us Privacy Terms Of Use • Disclaimer • SafeCompanies: Advertise on SAPTechnical.COM | Post JobContact Us  

Graphic Design by Round the Bend Wizards

footer image footer image