ABAP Test Cockpit (ATC) Administration (Settings)

By Mavee Solutions

This document details the basic settings we would need to do for the ABAP Test Cockpit configuration.

Go to transaction ATC -> ATC Administration -> Setup -> Configure ATC

By default, the screen would be in display mode. Click on Change button.

First, enable ATC Exemptions in the system as shown below:

Next change the results to “For any results”.

The ATC Behavior on transport release can be as per the requirement. If we set to “Block on any error”, no transports would be released if there is any ATC error. If it is set to “Inform on errors”, then it is like an information message. The user can ignore the same and proceed with the transport release.

Click here to continue...

Please send us your feedback/suggestions at webmaster@SAPTechnical.COM 

HomeContribute About Us Privacy Terms Of Use • Disclaimer • SafeCompanies: Advertise on SAPTechnical.COM | Post JobContact Us  

Graphic Design by Round the Bend Wizards

footer image footer image